NAME
amttool - remotely control Intel AMT managed machines.
SYNOPSIS
amttool host [ command ] [ arg(s) ]
DESCRIPTION
amttool is a perl script which speaks SOAP to Intel AMT managed
machines. It can query informations about the machine in question and
also send some commands for basic remote control.
host is the hostname or IP address of the machine amttool should
control. command is an optional command.
You must set fill AMT_PASSWORD environment variable with the AMT
password.
For more inforamtions on Intel AMT check amt-howto(7).
COMMANDS
info gather information (default).
reset [ special ]
reset machine, with optional special command (see section
below).
powerup [ special ]
turn on machine.
powerdown
turn off machine.
powercycle [ special ]
powercycle machine.
netinfo
print network configuration (requires AMT 2.5+).
netconf if link [ ip mask gw [ dns1 [ dns2 ]]]
configure network interface (requires AMT 2.5+). if is the
interface handle, link the link policy. If in doubt just feed
in what the netinfo command prints. ip is the IPv4 address,
mask the netmask, gw the default gateway, dns1 and dns2 are the
DNS Servers. If no IP configuration is specified the tool tries
to configure the machine in shared mac address mode with dhcp,
otherwise in separate mac address mode with static IP address.
Default for dns1 is the gateway address, for dns2 it is 0.0.0.0.
SPECIAL COMMANDS
Special commands can optionally be specified for reset, powerup and
powercycle. They change the default boot behavior of the machine.
bios Asks for the BIOS boot messages being redirected to serial-over-
lan.
pxe Network boot via PXE.
hd Boot from local disk.
hdsafe Boot from local disk (safe mode).
cd Boot from CD/DVD.
diag Boot in diagnostics mode.
ENVIRONMENT
AMT_PASSWORD
AMT password.
AMT_DEBUG
Enable debug output.
SEE ALSO
amtterm(1), gamt(1), amt-howto(7)
AUTHOR
(c) 2007 Gerd Hoffmann <kraxel@redhat.com>
(c) 2007,08 Gerd Hoffmann amttool(1)