NAME
winbond-diag - EEPROM setup and diagnostic program for Winbond w89c840
based Ethernet cards.
SYNOPSIS
winbond-diag [options]
DESCRIPTION
winbond-diag is a program that you can use to diagnose problems with
Ethernet cards based on the Winbond w89c840 chip.
OPTIONS
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (‘-’). A summary of options is
included below.
-h, --help
Show summary of options.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-q, --quiet
Be very unverbose.
-# <cardnum>
Use card number <cardnum>.
-a, --show_all_registers
Print all registers.
-e, --show-eeprom
Dump EEPROM contents to stdout.
-E, --emergency-rewrite
Re-write a corrupted EEPROM.
-p, --base-address <port>
Specify port to use.
-A, --Advertise <mediaype>
Advertise media type. Valid Options are: 10baseT, 100baseT4,
100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT, 10base2,
AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4,
100baseFx, 100baseFx-FDX, MII and Autosense.
-H, --new-hwaddress <address>
Set card to a new hardware address.
-m, --show-mii
Dump MII management registers.
-R, --reset
Reset the transceiver.
-T, --test
Do register and SRAM test.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this,
if you do not know what you do!
-f, --force-detection
Try to identify the card, even if it is active.
-t, --chip-type <card>
Explicitly set the chip. To get all valid numbers, run winbond-
diag with the options ’-t -1’.
SEE ALSO
mii-diag(8)
AUTHOR
winbond-diag was written and is still maintained by Donald Becker
<becker@scyld.com>. This manual page was written by Alain Schroeder
<alain@debian.org>, for the Debian GNU/Linux system (but may be used by
others).
February 18, 2002