NAME
atlantic-setup - Setup program for ethernet cards based on AT/LANTIC
DP83905 chips.
SYNOPSIS
atlantic-setup [options]
DESCRIPTION
atlantic-setup is a setup and diagnostic program for ISA NE2000
Ethernet adapters. It has specific support for configuring the National
Semiconductor AT/LANTIC DP83905 used in on ISA Ethernet adapters such
as the NE2000plus. It also works several work-alike chips from other
vendors.
OPTIONS
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (‘-’). A summary of options is
included below.
-h, --help
Show summary of options.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-q, --quiet
Be very unverbose.
-a, --all
Print all registers.
-N, --NE2000
Set card to NE2000 mode.
-W, --wd8013
Set card to WD8013 mode.
-p, --base-address <port>
Specify port to use. Valid values are: 0x240, 0x280, 0x300,
0x320, 0x340, 0x360 (default: 0x300).
-P, --new_ioport <port>
Set card to use new port. Valid values are: 0x240, 0x280, 0x300,
0x320, 0x340, 0x360 (default: 0x300).
-F, --interface <interface>
Interface number. Valid Options are: 10baseT, 10base2, 10base5,
AUI.
-Q, -i, --irq <irq>
Specify new interrupt. Valid values are: 3-5,9-12,15.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values.
SEE ALSO
mii-diag(8)
AUTHOR
This manual page was written by Alain Schroeder <alain@debian.org>, for
the Debian GNU/Linux system (but may be used by others).
March 8, 2001