NAME
al1700-diag - Diagnostic program for the Allied Telesis AT1700
SYNOPSIS
al1700-diag [options]
DESCRIPTION
al1700-diag is a diagnostic program for the Allied Telesis AT1700, and
similar boards built around the Fujitsu MB86965. It does not test
every possible hardware fault, but it does verify the basic
functionality ofthe board.
OPTIONS
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (‘-’). A summary of options is
included below.
-h, --help
Show summary of options.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-q, --quiet
Be very unverbose.
-a, --all
Print all registers.
-e, --show-eeprom
Dump EEPROM contents to stdout.
-p, --base-address <port>
Specify port to use.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT,
100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx,
100baseFx-FDX, MII and Autosense.
-P <address>
Set card to a new IO base address.
-Q <irq>
Set card to a new IRQ.
-m, --show-mii
Dump MII management registers.
-r, --reset-ASIC
Reset the ASIC.
-m Tests multicast.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this,
if you do not know what you do!
SEE ALSO
mii-diag(8)
AUTHOR
This manual page was written by Alain Schroeder <alain@debian.org>, for
the Debian GNU/Linux system (but may be used by others).
February 23, 2001 AL1700-DIAG(8)