NAME
wulfweb - A script to create an html table of cluster node statistics
SYNOPSIS
wulfweb [-d delay] [-f wulfhosts] [-i include] [-p path] [-t type] [-h]
[-v level] filename
WULFWEB OPTIONS
filename (required) is the name of the web page created (e.g.
mycluster.html)
-d delay sets the delay used for both wulflogger and page updates
-f wulfhosts to specify a particular wulfhosts file
-i include file (which must contain html intended to go after <html>
and before the table in the created web page).
-t type to control wulflogger "type" of display.
-h displays help/usage
-v level controls verbosity and debugging output
DESCRIPTION
wulfweb is a script that creates a web page containing an optional
inclusion (described in detail below) followed by an html table
formatted to contain automatically updated cluster statistics collected
from xmlsysd’s running on the cluster nodes by wulflogger. Note that
wulflogger is therefore required by the wulfweb program.
A typical invocation might be:
$ wulfweb -f /usr/share/wulfweb/wulfhosts -d 60 -t 1 \
-i myheader.html mycluster.html &
to create a page with the header myheader.html in front of the "load
averages" table that auto-refreshes every 60 seconds. The cluster is
described in the wulfhosts file (see wulfstat(1) or wulflogger(1) for
details). Run in the background, wulfweb will keep this page current
indefinitely.
INCLUDED FILE
The included file must contain valid html for material that you might
wish to precede the table. It can be empty (or no include file may be
given on the command line) in which case the raw table and the <meta>
tag that causes automatic refresh are the sole contents of the output
file.
The included header file can be as fancy as you like, but I’d strongly
urge that if you want to embed the tables in a complex document you
consider using php and including the table in a php-generated page, as
otherwise I think you’ll find this simple inclusion mechanism limiting.
Be warned! Check the resulting documents produced carefully for
errors! The most that wulfweb can do is produce the table (hopefully
correctly). Obviously it cannot be blamed for bad html in any
inclusion.
The following is an example of a reasonable inclusion that should work:
<html>
<head>
<title>MyCluster Stats</title>
</head>
<body>
<h2>MyCluster Load Average</h2>
<hr>
DISPLAY TYPES
The following display types are supported by wulflogger:
0 - a "vmstat-like" display of stats from all cluster hosts.
Probably
the most useful single display.
1 - load average only
2 - memory utilization (similar to running "free" on each host)
3 - network rates
4 - time displays system clocks, uptime, cpu type and clock
5 - pids interface for monitoring running distributed tasks.
6 - pids interface for monitoring running distributed tasks with
full command line displayed.
The pids interface (with or without the full command line displayed) is
a bit quirky. It will generally ignore root-owned tasks, for example,
presuming that the tool is intended to monitor userspace applications.
There exist wulfhosts controls for these properties; eventually they
will likely be controllable at the command line of this tool as well.
SEE ALSO
xmlsysd(8), wulfstat(1), wulflogger(1)
WARNING WARNING WARNING
Trust No One. Your Mileage May Vary. Use With Caution. Void Where
Prohibited. Use Your Head. I am NOT RESPONSIBLE for losses you
sustain based on the use of this software, which comes with NO WARRANTY
concerning suitability for any purpose and in fact may be quite useless
and misleading.
You Have Been Warned.
ACKNOWLEDGEMENT
Blessings on any and all who’ve ever contributed to the perl
programming language, from its inventors on down.