Name
mbadblocks - tests a floppy disk, and marks the bad blocks in the FAT
Note of warning
This manpage has been automatically generated from mtools’s texinfo
documentation, and may not be entirely accurate or complete. See the
end of this man page for details.
Description
The mbadblocks command is used to scan an MS-DOS floppy and mark its
unused bad blocks as bad. It uses the following syntax:
mbadblocks drive:
Mbadblocks scans an MS-DOS floppy for bad blocks. All unused bad blocks
are marked as such in the FAT. This is intended to be used right after
mformat. It is not intended to salvage bad disks.
Bugs
Mbadblocks should (but doesn’t yet :-( ) also try to salvage bad blocks
which are in use by reading them repeatedly, and then mark them bad.
See Also
Mtools’ texinfo doc
Viewing the texi doc
This manpage has been automatically generated from mtools’s texinfo
documentation. However, this process is only approximative, and some
items, such as crossreferences, footnotes and indices are lost in this
translation process. Indeed, these items have no appropriate
representation in the manpage format. Moreover, not all information
has been translated into the manpage version. Thus I strongly advise
you to use the original texinfo doc. See the end of this manpage for
instructions how to view the texinfo doc.
* To generate a printable copy from the texinfo doc, run the
following commands:
./configure; make dvi; dvips mtools.dvi
* To generate a html copy, run:
./configure; make html
A premade html can be found at
‘http://www.gnu.org/software/mtools/manual/mtools.html’
* To generate an info copy (browsable using emacs’ info mode),
run:
./configure; make info
The texinfo doc looks most pretty when printed or as html. Indeed, in
the info version certain examples are difficult to read due to the
quoting conventions used in info.