NAME
arrayprobe - command line HP (Compaq) SmartArray status checker
SYNTAX
arrayprobe [-f device] [-r] [-o] [-i]
DESCRIPTION
This program is capable of checking the status HP (Compaq) array
controllers (devices using the Linux cciss and ida drivers). By default
it runs in a non verbose mode that can be used as a nagios check or
periodic cron job.
OPTIONS
-f <device>
Device to open.
-r Report (verbose) mode.
-o Only read new events (since last run, CCISS devices only).
-i <host>
Force ida ioctls. (use with -f if the device is supported by the
ida driver)
STATUS
The output is a single line of information about the worst state found.
(If one logical drive is recovering and a second drive is in interim
recovery mode. It will only report the failing drive.) The exitcodes
can be used to determine the severity. The following exit values are
returned:
0 Normal.
1 Warning.
2 Critical.
BUGS
None known.
AUTHORS
Hugo Trippaers <spark@knoware.nl>