NAME
cfsetospeed - set output baud rate
SYNOPSIS
#include <termios.h>
int cfsetospeed(struct termios *termios_p, speed_t speed);
DESCRIPTION
The cfsetospeed() function shall set the output baud rate stored in the
structure pointed to by termios_p to speed.
There shall be no effect on the baud rates set in the hardware until a
subsequent successful call to tcsetattr() with the same termios
structure. Similarly, errors resulting from attempts to set baud rates
not supported by the terminal device need not be detected until the
tcsetattr() function is called.
RETURN VALUE
Upon successful completion, cfsetospeed() shall return 0; otherwise, it
shall return -1 and errno may be set to indicate the error.
ERRORS
The cfsetospeed() function may fail if:
EINVAL The speed value is not a valid baud rate.
EINVAL The value of speed is outside the range of possible speed values
as specified in <termios.h>.
The following sections are informative.
EXAMPLES
None.
APPLICATION USAGE
None.
RATIONALE
Refer to cfgetispeed() .
FUTURE DIRECTIONS
None.
SEE ALSO
cfgetispeed() , cfgetospeed() , cfsetispeed() , tcsetattr() , the Base
Definitions volume of IEEE Std 1003.1-2001, Chapter 11, General
Terminal Interface, <termios.h>
COPYRIGHT
Portions of this text are reprinted and reproduced in electronic form
from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology
-- Portable Operating System Interface (POSIX), The Open Group Base
Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of
Electrical and Electronics Engineers, Inc and The Open Group. In the
event of any discrepancy between this version and the original IEEE and
The Open Group Standard, the original IEEE and The Open Group Standard
is the referee document. The original Standard can be obtained online
at http://www.opengroup.org/unix/online.html .