epic-diag - EEPROM setup and diagnostic program for SMC EtherPowerII
ethernet cards and others.
epic-diag is a program that you can use to diagnose problems with
ethernet cards based on the SMC83C170 series EPIC/100 chip, as used on
the SMC EtherPowerII boards.
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (‘-’). A summary of options is
Show summary of options.
Show version of program.
Be very unverbose.
Use card number <cardnum>.
Print all registers.
Dump EEPROM contents to stdout.
Re-write a corrupted EEPROM.
-p, --port-base <port>
Specify port to use.
-A, --Advertise <mediaype>
Advertise media type. Valid Options are: 10baseT, 100baseT4,
100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT, 10base2,
AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4,
100baseFx, 100baseFx-FDX, MII and Autosense.
-H, --new-hwaddress <address>
Set card to a new hardware address.
Dump MII management registers.
Reset the transceiver.
Do register and SRAM test.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this,
if you do not know what you do!
Try to identify the card, even if it is active.
-t, --chip-type <card>
Explicitly set the chip. To get all valid numbers, run epic-diag
with the options ’-t -1’.
epic-diag was written and is still maintained by Donald Becker
<firstname.lastname@example.org>. This manual page was written by Alain Schroeder
<email@example.com>, for the Debian GNU/Linux system (but may be used by
February 18, 2002