atmloop - get/set loopback mode of ATM interfaces
atmloop -s [-l level] [-r level] [itf]
atmloop -q [itf]
atmloop sets or shows the current loopback settings of an ATM
interface, and allows to query the loopback modes supported by the
Some ATM cards can be configured to echo data back to the driver (local
loopback) or to the network (remote loopback). The echoing may be done
at several different levels:
aal AAL PDUs
atm ATM cells
bits sent to or received from the line interface
analog the analog signal
The levels supported by an interface can be queried with the -q option.
If invoked without options, atmloop displays the current loopback
-s set loopback mode. Followed by either -l or -r, both options to
set local and remote loopback at the same time (if supported by
the driver), or none of them to turn off any loopback.
enable local loopback.
enable remote loopback.
query loopback levels supported by the interface.
-V print version number of atmloop on standard output and exit.
Werner Almesberger, EPFL ICA <Werner.Almesberger@epfl.ch>