ieee1284_read_data, ieee1284_write_data, ieee1284_data_dir,
ieee1284_wait_data - control the data lines
int ieee1284_read_data(struct parport *port);
void ieee1284_write_data(struct parport *port, unsigned char dt);
int ieee1284_data_dir(struct parport *port, int reverse);
int ieee1284_wait_data(struct parport *port, unsigned char mask,
unsigned char val, struct timeval *timeout);
These functions manipulate the data lines of the parallel port
associated with port (which must have been claimed using
ieee1284_claim(3)). The lines are represented by an 8-bit number (one
line per bit) and a direction. The data lines are driven as a group;
they may be all host-driven (forward direction) or not (reverse
direction). When the peripheral is driving them the host must not.
For ieee1284_data_dir the reverse parameter should be zero to turn the
data line drivers on and non-zero to turn them off. Some port types may
be unable to switch off the data line drivers.
Setting the data lines may have side effects on some port types (for
example, some Amiga ports pulse nStrobe).
ieee1284_wait_data waits, up until the timeout, for the data bits
specified in mask to have the corresponding values in val.
ieee1284_read_data returns the 8-bit number representing the data lines
unless it is not possible to return such a value with this port type,
in which case it returns an error code. Possible error codes:
Bi-directional data lines are not available on this system.
The port parameter is invalid (perhaps it has not been claimed, for
There was an error at the operating system level, and errno has
been set accordingly.
The timeout has elapsed.
Whereas ieee1284_read_data may return E1284_NOTAVAIL on its first
invocation on the port, if it does not do so then it cannot until
ieee1284_close is called for that port.
Tim Waugh <email@example.com>
Copyright © 2001-2003 Tim Waugh