dup, dup2, dup3 - duplicate a file descriptor
int dup(int oldfd);
int dup2(int oldfd, int newfd);
int dup3(int oldfd, int newfd, int flags);
These system calls create a copy of the file descriptor oldfd.
dup() uses the lowest-numbered unused descriptor for the new
dup2() makes newfd be the copy of oldfd, closing newfd first if
necessary, but note the following:
* If oldfd is not a valid file descriptor, then the call fails, and
newfd is not closed.
* If oldfd is a valid file descriptor, and newfd has the same value as
oldfd, then dup2() does nothing, and returns newfd.
After a successful return from one of these system calls, the old and
new file descriptors may be used interchangeably. They refer to the
same open file description (see open(2)) and thus share file offset and
file status flags; for example, if the file offset is modified by using
lseek(2) on one of the descriptors, the offset is also changed for the
The two descriptors do not share file descriptor flags (the close-on-
exec flag). The close-on-exec flag (FD_CLOEXEC; see fcntl(2)) for the
duplicate descriptor is off.
dup3() is the same as dup2(), except that:
* The caller can force the close-on-exec flag to be set for the new
file descriptor by specifying O_CLOEXEC in flags. See the
description of the same flag in open(2) for reasons why this may be
* If oldfd equals newfd, then dup3() fails with the error EINVAL.
On success, these system calls return the new descriptor. On error, -1
is returned, and errno is set appropriately.
EBADF oldfd isn’t an open file descriptor, or newfd is out of the
allowed range for file descriptors.
EBUSY (Linux only) This may be returned by dup2() or dup3() during a
race condition with open(2) and dup().
EINTR The dup2() or dup3() call was interrupted by a signal; see
EINVAL (dup3()) flags contain an invalid value. Or, oldfd was equal to
EMFILE The process already has the maximum number of file descriptors
open and tried to open a new one.
dup3() was added to Linux in version 2.6.27; glibc support is available
starting with version 2.9.
dup(), dup2(): SVr4, 4.3BSD, POSIX.1-2001.
dup3() is Linux-specific.
The error returned by dup2() is different from that returned by
fcntl(..., F_DUPFD, ...) when newfd is out of range. On some systems
dup2() also sometimes returns EINVAL like F_DUPFD.
If newfd was open, any errors that would have been reported at close(2)
time are lost. A careful programmer will not use dup2() or dup3()
without closing newfd first.
close(2), fcntl(2), open(2)
This page is part of release 3.24 of the Linux man-pages project. A
description of the project, and information about reporting bugs, can
be found at http://www.kernel.org/doc/man-pages/.