AICCU - Automatic IPv6 Connectivity Configuration Utility
aiccu <start|stop|tunnels|test|autotest|license> [ config ]
AICCU makes it very easy for anybody to get IPv6 connectivity
everywhere they want. It uses the TIC (Tunnel Information & Control)
protocol to request the information needed to setup a tunnel through
which the connectivity is created. AICCU supports the following
tunneling protocols: - 6in4 static (RFC 2893) - 6in4 heartbeat (RFC
2893 + draft-massar-v6ops-heartbeat) - tinc (http://www.tinc-
vpn.org) - AYIYA (draft-massar-v6ops-ayiya) As AYIYA even
works from behind NAT's, thus unless there is a very restrictive
firewall in place, anybody should be able to get IPv6 connectivity
without problems and everywhere they want.
start Starts aiccu service.
stop Stops aiccu service.
Prints a list of currently available tunnels.
test Builds the connection and runs a simple selftest allowing a user
to report this back as it should show most obvious problems.
Shows the license aiccu is released under.
config Read the configuration from config file.
The AICCU page <URL:http://www.sixxs.net/tools/aiccu/> at sixxs.
AICCU was written by Jeroen Massar with contributions supplied a number
of people as mentioned in the Changelog.
18 April 2005